F 350 2WD Super Duty V10-6.8L (2009)
Air Bag: Service and Repair
Passenger Air Bag Module
Passenger Air Bag Module
Removal
WARNING: Always carry or place a live air bag module with the air bag and deployment door/trim cover/tear seam pointed away from the
body. Do not set a live air bag module down with the deployment door/trim cover/tear seam face down. Failure to follow these instructions may
result in serious personal injury in the event of an accidental deployment.
WARNING: Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules. Failure to follow this instruction
may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
NOTICE: Do not install a new passenger air bag module assembly due to a damaged or discolored passenger air bag cover. The passenger air
bag cover can be serviced separately from the passenger air bag module assembly. For additional information, refer to Air Bag Trim Cover -
Passenger See: Air Bag Trim Cover - Passenger.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures.
2. Open and lower the glove compartment door.
3. Remove and discard the 4 passenger air bag cover screws.
