F 350 2WD Super Duty V10-6.8L (2009)
5. Push in the locking tab and disconnect the Passenger Air Bag Deactivation (PAD) switch electrical connector and remove the instrument panel
control opening bezel.
6. Remove the 3 screws and PAD switch.
7. To install, reverse the removal procedure.
8. Prove out the Supplemental Restraint System (SRS) as follows:
Turn the ignition from ON to OFF. Wait 10 seconds, then turn the ignition ON and monitor the air bag warning indicator with the air bag modules
installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn off. If an air bag SRS fault is detected,
the air bag warning indicator will:
-
fail to light.
-
remain lit continuously.
-
flash.
The flashing might not occur until approximately 30 seconds after the ignition has been turned from the OFF to the ON position. This is the time
required to complete testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault exists, a chime will sound in a pattern of 5
sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be diagnosed and repaired.
Clear all RCM CMDTCs.
