F 350 2WD Super Duty V10-6.8L (2009)
3. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in Safety
Belt System See: Testing and Inspection/Component Tests and General Diagnostics.
Safety Belt - Front, SuperCab and Crew Cab, Bench Seat
Safety Belt - Front, SuperCab and Crew Cab, Bench Seat
NOTE: Center safety belt shown.
Removal and Installation
WARNING: After any crash, all of the following safety belt assemblies and attaching hardware must be inspected by an authorized dealer to
verify correct function:
-
Retractors
-
Buckles
-
Belt tension sensor (BTS) (if equipped)
-
Front safety belt buckle support assemblies (slide bar) (if equipped)
-
Safety belt shoulder belt height adjusters (if equipped)
-
Child safety seat tether bracket assemblies
-
Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)
If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and
Testing, a new safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet
metal must be restored to its original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure
to install new safety belt assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or
front outboard passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new
safety belt systems increases the risk of serious personal injury or death in a crash.
1. Remove the bolt and safety belt.
-
Pull the safety belt through the top of the seat cushion.
-
To install, tighten to 55 Nm (41 lb-ft).
2. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
3. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in Safety
Belt System See: Testing and Inspection/Component Tests and General Diagnostics.
