F 350 2WD Super Duty V10-6.8L (2009)
Removal and Installation
WARNING: After any crash, all of the following safety belt assemblies and attaching hardware must be inspected by an authorized dealer to
verify correct function:
-
Retractors
-
Buckles
-
Belt tension sensor (BTS) (if equipped)
-
Front safety belt buckle support assemblies (slide bar) (if equipped)
-
Safety belt shoulder belt height adjusters (if equipped)
-
Child safety seat tether bracket assemblies
-
Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)
If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and
Testing, a new safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet
metal must be restored to its original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure
to install new safety belt assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or
front outboard passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new
safety belt systems increases the risk of serious personal injury or death in a crash.
RH/ LH center safety belt buckles
1. Using an appropriate tool, push in the pin hole while pulling the safety belt tongue out of the safety belt buckle.
-
After installation, when inserting the safety belt tongue into the safety belt buckle, make sure the safety belt buckle and safety belt retractor
webbing are not incorrectly twisted.
All safety belt buckles
2. Fold the second row bench seat backrest forward.
-
Remove the affected safety belt buckle(s) from between the seat backrest and cushion.
3. Remove the affected safety belt buckle(s).
-
Remove the bolt and LH outboard safety belt buckle.
-
To install, tighten to 40 Nm (30 lb-ft).
-
Remove the 2 bolts and RH/ LH center safety belt buckles.
-
To install, tighten to 40 Nm (30 lb-ft).