F 350 2WD Super Duty V10-6.8L (2009)
4. Install the tapered end of the strap through the opening of the cradle on the hinge side of the sensor. This will position the worm gear on the
locking clip side of the sensor.
5. NOTICE: Steel wheels have a "high spot" along their circumference. Make sure the strap and sensor are mounted at the lowest spot
possible to avoid damaging the sensor during wheel and tire disassembly and assembly.
NOTE: Keep the strap parallel with the wheel flange while tightening the worm gear.
Position the worm gear 13-26 mm (0.5-1.0 in) away from the sensor and tighten the worm gear.
-
Tighten to 3 Nm (27 lb-in).
6. NOTICE: The sensor, cradle and strap may be damaged by incorrect tire mounting or dismounting. Mount the tire only as instructed.
Install the tire onto the wheel. For additional information, refer to Wheel and Tire See: Wheels and Tires/Service and Repair/Overhaul.
7. NOTE: A new tire pressure sensor is shipped in an off mode (or battery saver mode) and must be turned on before it can be trained. To turn the
sensor on, install it on a wheel, mount the tire and inflate the tire to the recommended inflation pressure. Wait at least 2 minutes, then continue
with the sensor training procedure.
Train the tire pressure sensor(s). For additional information, refer to Tire Pressure Monitoring System (TPMS) Sensor Training See: Wheels and
Tires/Tire Monitoring System/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.
