F 350 2WD Super Duty V10-6.8L (2009)
13. Using the Worm Bearing Locknut Installer, remove the worm thrust bearing retainer ring.
14. Remove the input shaft and control from the valve housing.
15. Rotate the holding fixture 180 degrees.
16. NOTICE: Do not allow the screwdriver to make contact with the valve housing bore, or damage to the sealing area may occur, causing a
fluid leak.
Using a screwdriver, remove and discard the input shaft dust seal.
17. Remove and discard the input shaft seal snap ring.
18. Rotate the holding fixture 180 degrees.
19. Using the Steering Gear Bearing Remover/Installer and the Steering Gear Bushing Installer, remove the input shaft bearing and input shaft seal.
-
Discard the input shaft seal.
