F 350 2WD Super Duty V10-6.8L (2009)
Stabilizer Link: Service and Repair
Front Suspension
Stabilizer Bar and Link - F-250, F-350
Removal and Installation
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result
in major service expense. They must be replaced with the same part number or an equivalent part if replacement is necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct
retention of these parts.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove and discard the stabilizer bar link upper nuts, washers and bolts.
-
To install, tighten the new nut to 115 Nm (85 lb-ft).
3. Remove the stabilizer bar link lower nuts, washers, bolts and the stabilizer bar links.
-
Discard the nuts, bolts and washers.
-
To install, tighten the new nuts, bolts and washers to 115 Nm (85 lb-ft).
4. Remove the stabilizer bar bracket nuts, brackets and the stabilizer bar.
-
Discard the nuts.
-
To install, tighten the new nuts to 48 Nm (35 lb-ft).
5. To install, reverse the removal procedure.
