F 350 2WD Super Duty V10-6.8L (2009)
Removal
All vehicles
1. Remove the driveshaft.
Four-Wheel Drive (4WD) vehicles
2. Remove the transfer case.
Transmissions with a fixed flange
3. Remove the output shaft flange.
1. Remove and discard the output shaft flange bolt.
2. Remove the output shaft flange.
4. Using the Output Shaft Locknut Socket, remove and discard the output shaft nut.
5. Using the Transmission Extension Housing Seal Remover along with the Torque Converter Fluid Seal Remover and Slide Hammer, remove the
output shaft seal.
Transmissions without a fixed flange
6. Using the Transmission Extension Housing Seal Remover along with the Torque Converter Fluid Seal Remover and Slide Hammer, remove the
extension housing seal.