F 350 2WD Super Duty V10-6.8L (2009)
6. Turn the engine OFF.
7. Measure the amount of transmission fluid in the container. If the amount of transmission fluid measured is approximately 600 ml (20.4 oz), the
transmission fluid cooling system is functioning correctly. Reinstall all of the components. If the amount of transmission fluid measured is not as
specified, proceed as follows.
8. Disconnect the in-tank transmission fluid cooler inlet tube (bottom fitting) from the transmission.
9. Connect one end of the hose to the transmission fluid outlet fitting on the transmission case and insert the other end into the transmission fluid fill
hole in the transmission case.
10. Start the engine and run it at idle with the transmission in NEUTRAL.
11. Remove the end of the hose from the transmission fluid fill hole in the transmission case and place it into a measuring container for 15 seconds.
After 15 seconds, insert the end of the hose back into the transmission fluid fill hole in the transmission case.
12. Turn the engine OFF.
13. Measure the amount of transmission fluid in the container. If the amount of transmission fluid measured is approximately 600 ml (20.4 oz), the
in-tank transmission fluid cooler/fluid cooler tubes are damaged, blocked or restricted. Repair as necessary. If the amount of transmission fluid
measured is not as specified, repair or install a new pump in the transmission.
14. Fill with full synthetic manual transmission fluid and check for leaks.
