F 350 2WD Super Duty V10-6.8L (2009)
Wiring Harness: Service and Repair
TorqShift
Internal Harness Service
Removal
1. Remove the solenoid body assembly. For additional information, refer to Solenoid Body Assembly See: Valve Body/Service and Repair.
2. Disconnect the transmission internal harness.
1. Remove the 2 screws.
2. Disconnect the Transmission Fluid Temperature (TFT) sensor.
3. Disconnect the solenoid connectors.
3. Remove the transmission internal harness connector O-ring seal.
4. Lift the tab. Twisting the transmission internal harness connector, push it through the solenoid body and remove the wire harness.
Installation
1. Push the transmission internal harness connector through the transmission solenoid body, twist it to lock it in place.
2. Connect the transmission internal harness.
1. Install the 2 screws.
2. Connect the TFT sensor.
3. Connect the solenoid connectors.
