F 350 2WD Super Duty V10-6.8L (2009)
components as necessary.
Assembly
1. Fill the driveshaft slip yoke boot with approximately 10 g (0.36 oz) of grease.
2. Position the driveshaft slip yoke boot clamp on the stub shaft.
3. Slide the driveshaft slip yoke boot over the stub shaft, and seat it in the boot groove.
4. Using the Constant Velocity Joint Boot Clamp Installer, install the driveshaft slip yoke boot clamp.
5. Install the driveshaft slip yoke.
1. Position the driveshaft slip yoke boot clamp.
2. Lubricate the stub shaft splines with grease.
3. Align the index marks and install the driveshaft slip yoke.
4. Seat the driveshaft slip yoke boot in the boot groove.