F 350 2WD Super Duty V10-6.8L (2009)
3. Using the Output Shaft Oil Seal Installer (4x2), install a new output oil seal.
4. Apply threadlock to the threads of the transmission output flange locknut. Using the Drive Pinion Flange Holding Fixture with the Mainshaft
Locknut Socket, install the transmission flange and transmission output flange locknut.
-
Tighten to 330 Nm (244 lb-ft).
All vehicles
5. NOTE: Make sure the index marks made during removal are aligned.
Connect the rear driveshaft.
6. For vehicles equipped with a gasoline engine, install new driveshaft flange bolts.
-
Tighten to 102 Nm (75 lb-ft).
7. For vehicles equipped with a diesel engine, install new driveshaft flange bolts.
-
Tighten to 111 Nm (82 lb-ft).
8. For other driveshaft configurations, refer to Drive/Propeller Shafts, Bearings and Joints. See: Drive/Propeller Shafts, Bearings and Joints
