F 350 2WD Super Duty V10-6.8L (2009)
10. WARNING: Do not drive vehicle until the urethane adhesive seal has cured. Follow urethane adhesive manufacturer's curing directions.
Inadequate or incorrect curing of the urethane adhesive seal will adversely affect glass retention. Failure to follow these instructions may
result in serious injury to vehicle occupant(s).
NOTICE: Before positioning the windshield glass, open vehicle windows to prevent the air pressure of closing doors from affecting the
urethane adhesive bond.
Using the alignment marks made previously, position the windshield glass on the pinch weld.
11. NOTE: The urethane adhesive must cure for a minimum of one hour before testing for air or water leaks.
Check the glass installation for air or water leaks.
12. Install the sun visors.
13. Install the overhead console.
14. Install the A-pillar trim panels.
15. Install the interior rear view mirror.
16. Install the cowl panel grille.
