F 350 2WD Super Duty V10-6.8L VIN S (1999)
1.
Using a drill, enlarge three existing holes in the left-hand frame rail as indicated. These holes will be used for installing the mounting bracket.
Please note that two holes will be enlarged to 13 mm and the third will be enlarged to 11 mm. See Figure 2.
WARNING:
DO NOT SMOKE OR CARRY LIGHTED TOBACCO OR HAVE OPEN FLAME OF ANY TYPE WHEN WORKING ON OR NEAR ANY
FUEL RELATED COMPONENT. HIGHLY FLAMMABLE MIXTURES ARE ALWAYS PRESENT AND MAY BE IGNITED, RESULTING IN
POSSIBLE PERSONAL INJURY OR PROPERTY DAMAGE.
a.
Loosen the fuel filler tube hose clamp and separate the filler tube from the fuel filler neck. See Figure 3.
b.
Drain the fuel from the fuel tank.
c.
Remove the fuel tank skid plate (if equipped).