F 350 2WD Super Duty V10-6.8L VIN S (1999)
4.
Rotate the fuel tank strap insulator 180 degrees on the fuel tank strap. Make sure the parting line matches the opening on the insulator, and the end
of the insulator is approximately 60 mm (2.36 in) from the hinged end of the fuel tank strap. See Figure 7.
5.
Position the fuel tank strap on the fuel tank and install the retaining bolt. Tighten the bolt to 40 Nm (30 lb-ft).
6.
Remove the jack stand and lower the vehicle.
Repair # 3 - Pickup Box Cable Installation
1.
Working through the left rear wheel opening, remove the parking brake cable bracket bolt and discard. See Figure 8.
a.
Position the pickup box cable through the hole in the pickup box channel brace as shown in Figure 8.
