F 350 2WD Super Duty V10-6.8L VIN S (1999)
6.
Disconnect the intermediate cable from the front cable at the connecting clip and discard the connecting clip. See Figure 2.
7.
Disconnect the parking brake release handle cable from the parking brake control assembly.
8.
Remove the scuff plate from the driver door opening.
9.
Remove the left kick panel trim cover.
10.
Remove the three (3) parking brake control assembly retaining nuts.
11.
Position the parking brake control assembly to gain access to the hood release cable and disconnect it from the control assembly.
12.
From under the vehicle, push the grommet attached to the front cable conduit up through the floor. See Figure 3.
13.
WARNING: THE PARKING BRAKE CONTROL ASSEMBLY IS UNDER TENSION. USE CAUTION WHEN REMOVING IT FROM THE
VEHICLE.
Remove the parking brake control assembly and front cable from the vehicle.
FRONT PARKING BRAKE CABLE AND CONTROL ASSEMBLY INSTALLATION - ALL VEHICLES
