F 350 2WD Super Duty V10-6.8L VIN S (1999)
Apply a bead of silicone around the rear oil seal retainer sealing surface.
^
Use Silicone Gasket and Sealant F6AZ-19562-AA or equivalent meeting Ford specification WSE-M4G323-A6.
3. NOTE: If the rear main oil seal is still in place and being reinstalled, be sure the lip is not folded over or wrinkled during the retainer plate
installation. The seal lip must start squarely on the crankshaft journal.
Position the crankshaft rear oil seal and retainer, install the bolts. Then install the oil pan and the two bolts. Tighten in two stages.
^
Stage 1: Tighten retainer plate bolts to 8-12 Nm (71-107 inch lbs.)
^
Stage 2: Tighten oil pan bolts to 14-20 Nm (10-15 ft. lbs.) then tighten an additional 90°
4. Use the Rear Crankshaft Seal Replacer and Rear Crankshaft Seal Adapter to install the crankshaft rear oil seal.
5. With the Rear Crankshaft Seal Adapter still installed, use the Rear Crankshaft Slinger Replacer and Rear Crankshaft Seal Replacer to install the
crankshaft oil slinger.
6. Install the flywheel.
7. Connect the battery ground cable.
