F 350 2WD Super Duty V10-6.8L VIN S (1999)
Clutch Fluid: Service and Repair
Bleeding - Clutch Hydraulic System
1. Fill the clutch master cylinder reservoir to the full line with DOT 3 Brake Fluid.
^
Use Ford High Performance DOT 3 Motor Vehicle Brake Fluid C6AZ-19542-AB or DOT 3 equivalent meeting Ford specification
ESA-M6C25-A.
2. Verify that the reservoir-to-master cylinder tube routing is as shown so as not to trap air in the clutch hydraulic system. Correct the routing as
necessary.
3. Raise and support the vehicle.
4. Unlock, and remove the slave cylinder from the transmission.
^
Compress and twist the slave cylinder to unlock it from the transmission.
5. Disconnect the clutch hydraulic tube from the floor pan clip.
6. Position the slave cylinder and the hydraulic tube so that there are no high points that could trap air in the system.
