F 350 2WD Super Duty V10-6.8L VIN S (1999)
1. Follow the removal procedure in reverse order.
^
For Dana 80, install the rear bearing cups using the Bearing Cup Replacer and Threaded Drawbar.
^
For Dana S135, install the rear bearing cups using the Inner and the Outer Hub Bearing Race Installer and the Driver Handle.
-
Check for proper seating of the new bearing cups by trying to insert a 0.038 mm (0.0015 inch) feeler gauge between the cups and the rear
hub. The gauge should not enter beneath the cup. Check in several places to be sure the cups are seated.
2. Install anew rear hub seal using a suitable seal replacer (Inner Hub Seal Installer and the Driver Handle for Dana S135).
3. Wrap the threads of the spindle with electrician's tape to prevent damage while installing the rear hub and rotor assembly.
^
Lightly coat the spindle and pack each rear wheel bearing with Premium Long-Life Grease XG-1-C or equivalent meeting Ford specification
ESA-M1C75-B.
4. Apply inward pressure to the socket to separate the ratcheting components of the hub nut. Tighten to specification.
