F 350 2WD Super Duty V10-6.8L VIN S (1999)
Crankshaft Position Sensor: Service and Repair
REMOVAL
CAUTION: Always disconnect the battery ground cable prior to working on the electronic engine controls.
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Release tension on the accessory drive belt.
4. Remove the A/C compressor.
5. Disconnect the wiring at the sensor.
6. Remove the bolt and the Crankshaft Position sensor.
NOTE: The crankshaft pulley is removed for clarity.
INSTALLATION
1. Follow the removal procedure in reverse order.
