F 350 2WD Super Duty V10-6.8L VIN S (1999)
Drive/Propeller Shaft: Service and Repair
Two-Piece
Removal
1. Raise and support the vehicle.
2. Index mark the driveshaft at the axle flange.
3. WARNING: Replace with new bolts and retainers after the third removal.
Disconnect the driveshaft from the axle flange.
1
Mark and remove the driveshaft to rear axle bolts.
2
Remove the U-joint retainers.
^
Using mechanics wire, support the driveshaft.
4. WARNING: Replace with new bolts after the third removal.
