F 350 2WD Super Duty V10-6.8L VIN S (1999)
5. Install the driveshaft slip yoke.
1
Position the driveshaft slip yoke boot clamp.
2
Pull the driveshaft slip yoke boot toward the stub shaft tube.
3
Lubricate the stub shaft splines.
4
Align the index marks, and install the driveshaft slip yoke.
^
Remove all excess grease from the slip yoke boot and the slip yoke.
5
Seat the driveshaft slip yoke boot into the boot groove.
6. For the front driveshaft, using the CV Boot Clamp Tool, install the driveshaft slip yoke boot clamps. Tighten the tool until the clamp is secure.
7. For all except the front driveshaft, install the driveshaft slip yoke boot clamp.
1
Measuring from the driveshaft weld to the U-joint centerline, position the driveshaft slip yoke to the distance specified.
2
Bleed the air from the driveshaft slip yoke boot.
3
Use the Keystone Clamp Pliers to crimp the driveshaft slip yoke boot clamp.
