F 350 2WD Super Duty V8-5.4L (2008)
9. Remove the center safety belt retractor.
1
Remove the 2 center safety belt retractor D-ring nuts (1 shown).
-
To install, tighten to 30 Nm (22 lb-ft).
2
Separate the center safety belt retractor D-ring from the sheet metal.
3
Remove the center safety belt retractor bolt.
-
To install, tighten to 30 Nm (22 lb-ft)
4
Slide the center safety belt retractor up, releasing the tab and remove the center safety belt retractor.
10. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
-
Make sure the safety belt buckles are accessible to the occupant after installation.
11. Check the active restraint system for correct operation.
