F 350 2WD Super Duty V8-5.4L (2008)
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard
passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the
risk of serious personal injury or death in a crash.
1. Remove the rear seat backrest.
2. Remove the B-pillar trim panel.
3. Remove the safety belt retractor.
-
Remove the bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
-
Disengage the safety belt retractor anti-rotation tab from the sheet metal and remove the safety belt retractor.
4. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
5. Check the active restraint system for correct operation.
Safety Belt Retractor and Pretensioner - Front, Crew Cab
SAFETY BELT RETRACTOR AND PRETENSIONER - FRONT, CREW CAB
