F 350 2WD Super Duty V8-5.4L (2008)
^
To install, tighten to 35 Nm (26 ft. lbs.).
5. Remove the 2 bolts and the power steering pump.
^
To install, tighten to 25 Nm (18 ft. lbs.).
6. NOTE: Make sure that the power steering pump bolts are installed in their original positions.
NOTE: Thoroughly clean all foreign material from the pressure line-to-pump threads before installing the fitting.
To install, reverse the removal procedure.
^
Using the special tool, install a new Teflon(R) seal on the pressure line fitting.
^
Fill the power steering system.
