F 350 2WD Super Duty V8-5.4L (2008)
5. Separate the lower shift lever and gearshift lever blocks from the shift housing.
Installation
1. Install the lower gearshift lever and gearshift lever blocks into the shift housing.
^
Install the gearshift lever blocks with the notches facing downward.
2. CAUTION: Do not use a silicone sealing compound.
NOTE: Do not wait longer than 10 minutes to tighten the bolts due to the rapid cure time of the sealant.
Install the shift housing.
^
Apply Gasket Maker to the sealing surfaces.
^
Tighten to 23 Nm (17 ft. lbs.).
3. Install the lower shift lever boot.
4. Apply Threadlock(R) and Sealer to the gearshift lever bolts, and install the upper gearshift lever.
^
Tighten to 35 Nm (26 ft. lbs.).
5. Install the shift lever boot.