F 350 2WD Super Duty V8-5.4L SOHC VIN L (2002)
3. NOTE: Index-mark the flange to the pinion shaft.
While using a suitable tool to prevent the flange or yoke from turning, remove the pinion nut.
4. Using the 2 Jaw Puller, remove the flange or yoke.
5. Using the Bushing Remover and the Slide Hammer, remove the pinion seal.
6. Clean the rear axle pinion seal seat.
Installation
1. CAUTION: If the pinion seal becomes cocked during installation, remove the seal and install a new one. Make sure the garter spring remains in
place during assembly. If the spring is dislodged, a new pinion seal must be installed.
Install the seal using a suitable driver.
-
Coat the pinion seal (rubber lips) with lubricant.
2. Using the special tool, install the pinion flange.
