F 350 2WD Super Duty V8-5.4L SOHC VIN L (2002)
NOTE: Align the rubber-coated sealing washers while installing CBV assembly on the transmission case.
Install the CBV assembly.
3. Install the fluid cooler tubes in the front and rear cooler line case fittings.
4. Caution: Install a new inline transmission fluid filter (XC3Z-7B155-BA) and always as part of a transmission overhaul or exchange. If the vehicle
was not equipped with an inline fluid filter, install a new inline transmission fluid filter kit (XC3Z-7B155-AA) according to the instructions
supplied with the kit as part of a transmission overhaul or exchange.
Caution: Failure to follow the instructions supplied with the inline transmission fluid filter kit can cause transmission damage.
Verify that the flow arrow on the filter points toward the transmission.
If the vehicle was equipped with an inline transmission fluid filter, install a new inline transmission fluid filter (XC3Z-7B155-BA). If the vehicle
was not equipped with an inline fluid filter, install a new transmission fluid filter (XC3Z-7B155-AA). Carry out the transmission fluid cooler flow
test procedure to verify that there is correct fluid flow through the new inline fluid filter.
5. Lower the vehicle.
6. Caution: Do not use any fluid approved for MERCON(R) V application. Using a fluid rated for MERCON(R) V may cause internal damage in
MERCON(R) only applications.
Fill the transmission with the specified type and quantity of transmission fluid.
7. Check for leaks.
