F 350 2WD Super Duty V8-5.4L VIN 5 (2006)
7. Remove the 2 screws on the seat control switch.
Installation
1. Position the seat control switch and install 2 screws.
2. Connect the seat control switch electrical connector.
3. NOTE: Bend the side shield slightly to make sure the shield is not scratched by the recliner lever.
Position the side trim cover. Install the 3 trim cover screws.
-
The seat backrest pivot bolt shaft must be inserted into the cover standoff.
4. Push the rearward lower corner of the side shield to engage the metal retaining clip.