F 350 2WD Super Duty V8-5.4L VIN 5 (2006)
2. For bench priming, mount the brake master cylinder in a vise.
3. install short brake tubes with the ends submerged in the brake master cylinder reservoir, and fill the brake master cylinder reservoir with specified
brake fluid.
4. Have an assistant pump the brake pedal, or slowly press the primary piston until clear fluid flows from both brake tubes, without air bubbles.
5. If the brake master cylinder is being primed at the bench, install it in the vehicle.
6. Remove the short brake tubes, and install the brake outlet tubes.
7. Bleed each brake tube at the brake master cylinder as follows:
1
Have an assistant pump the brake pedal, and then hold firm pressure on the brake pedal.
2
Loosen the rearmost brake tube fittings until a stream of brake fluid comes out. While the assistant maintains pressure on the brake pedal,
tighten the brake tube fitting.
^
Tighten to 25 Nm (18 ft. lbs.).
3
Repeat this operation until clear, bubble-free fluid comes out.
4
Refill the brake master cylinder reservoir as necessary. Repeat the bleeding operation at the front brake tube.
