F 350 2WD Super Duty V8-5.4L VIN 5 (2006)
Seat Belt Buckle: Service and Repair
Safety Belt Buckle - Front, Captain Chair
SAFETY BELT BUCKLE - FRONT, CAPTAIN CHAIR
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensor (BTS), if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
All seats
NOTE: Driver side shown, passenger side similar.
1. Remove the affected seat.
Driver seat
2. Disconnect the safety belt buckle switch electrical connector and separate it from the mounting bracket.
3. Remove the front inboard track-to-seat pan bolt.
-
To install, tighten to 25 Nm (18 lb-ft).
4. Loosen the rear inboard track-to-seat pan bolt to allow removal of the electrical connector.
