ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Safety Belt Buckle - Front, Bench Seat|Page 9093 > < Safety Belt Buckle - Front, Bench Seat|Page 9091
Page 1
background image

Seat Belt Buckle: Service and Repair

Safety Belt Buckle - Front, Bench Seat

SAFETY BELT BUCKLE - FRONT, BENCH SEAT

Removal and Installation

WARNING:  All safety belt assemblies (including retractors, belt tension sensor (BTS), if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions
.

1. Remove the utility tray, if necessary.

2. Remove the safety belt buckles.

1

Remove the bolt and the LH safety belt buckle.
-

To install, tighten to 40 Nm (30 lb-ft).

2

Disconnect the safety belt warning indicator switch connector.

3

Remove the bolt and the RH safety belt buckle.
-

To install, tighten to 40 Nm (30 lb-ft).

3. NOTE:  Make sure the safety belt webbing is not twisted prior to installation.

To install, reverse the removal procedure.

4. Check the restraint system for correct operation.

Safety Belt Buckle - Front, 40/20/40 Seat, Driver and Passenger

SAFETY BELT BUCKLE - FRONT, 40/20/40 SEAT, DRIVER AND PASSENGER

Removal and Installation

WARNING:  All safety belt assemblies (including retractors, belt tension sensor (BTS), if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions
.

All seats

NOTE:  Driver side shown, passenger side similar.

1. Remove the affected seat.

Driver seat

Safety Belt Buckle - Front, Bench Seat|Page 9093 > < Safety Belt Buckle - Front, Bench Seat|Page 9091