F 350 2WD Super Duty V8-5.4L VIN 5 (2006)
All seats
6. Remove the nut and the safety belt buckle.
-
To install, tighten to 40 Nm (30 lb-ft).
7. To install, reverse the removal procedure.
8. Check the active restraint system for correct operation.
Safety Belt Buckle - Front, With Seat Integrated Restraints (SIR)
SAFETY BELT BUCKLE - FRONT, WITH SEAT INTEGRATED RESTRAINTS (SIR)
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensor (BTS), if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
NOTE: Driver side shown, passenger side similar.
All seats
1. Remove the seat on the side with the affected safety belt buckle.
Driver seat
2. Remove the safety belt buckle switch electrical connector from the seat cushion pan.
All seats
