F 350 2WD Super Duty V8-5.4L VIN 5 (2006)
4. CAUTION: It may be necessary to tap the driveshaft yoke with a plastic or rubber soft-faced hammer if a pry area is not present on the
driveshaft yoke.
NOTE: Index-mark the driveshaft to the transmission flange.
Remove and discard the bolts. Disconnect the driveshaft from the transmission.
^
Using mechanic's wire, support the driveshaft.
^
To install, tighten to 102 Nm (75 lb-ft).
5. Index-mark the output shaft to the slip yoke.
6. Remove the center bearing support bolts.
^
To install, tighten to 63 Nm (46 lb-ft).
7. Remove the driveshaft assembly.
8. Clean grease deposits, dirt and rust from:
^
The driveshaft flange yoke areas.
^
All driveshaft slip yoke areas.
9. Inspect the following:
^
The driveshaft slip yoke boot for rips or holes. Install a new boot if necessary.
^
The driveshaft center bearing support for wear or rough action. If roughness or wear is evident, install a new driveshaft center bearing support.
^
The center bearing rubber insulator for evidence of hardening, cracking or deterioration. Install a new insulator if necessary.
10. NOTE: Lubricate the slip yoke spline with grease.
