F 350 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
Leak Detection Valve: Service and Repair
EVAPORATIVE EMISSION CANISTER VENT SOLENOID
REMOVAL
1. Disconnect the canister vent solenoid electrical connector.
2. NOTE: A twisting and pulling motion is necessary to remove the canister vent solenoid.
Remove the canister vent solenoid from the evaporative emission (EVAP) canister.
INSTALLATION
1. NOTE:
-
Inspect and install new O-ring seals as necessary.
-
Lubricate all O-ring seals with MERPOL(R) O-ring Seal Lubricant or equivalent meeting Ford specification ESE-M99B144-B.
To install, reverse the removal procedure.
-
Carry out the evaporative emissions canister leak test. See: Testing and Inspection/Component Tests and General Diagnostics/Evaporative
Emission System Leak Test
-
Carry out the evaporative emission repair verification drive cycle. See: Testing and Inspection/Component Tests and General
Diagnostics/Evaporative Emission Repair Verification Drive Cycle