F 350 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
7.
Remove the generator as follows. See Figure 3.
a)
Position the rubber cover aside and disconnect the B+ electrical connector.
b)
Disconnect the generator electrical connector.
c)
Remove the generator mounting bolts (two [2] stud bolts and the one [1] hex-head bolt).
d)
Remove the generator from the vehicle.
8.
Proceed to Sensor Connector Replacement in this Attachment III.
SENSOR CONNECTOR REPLACEMENT
NOTE:
All splices are to be made using tools provided in the Rotunda Wire Splice Tool Kit 164-R5903. The repair kit contains the connector and pigtail,
butt splice connectors and heat shrink tubing.
1.
Disconnect the ICP sensor. See Figure 4.
2.
Remove the tape from the vehicle harness back to the original take-out location.
3.
CAUTION: The replacement connector has only one (1) color wire, so location identification is crucial for a proper repair.
