F 350 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
5.
Hand tighten the new line tube nut into the steering gear.
6.
Position the cooler-to-gear line into clip. Reposition cooler to reservoir line so that there is no contact between the two lines near the gear. Close
clip and reattach clip to radiator support using new push pin (390018-S).
7.
Install cooler hose onto line, make sure it is fully seated all the way to stop bead. Position spring clamp so that it is between 1/8 to 3/16" (2-4 mm)
from the end of the hose.
8.
Torque tube nut at gear to 26 lb-ft (35 N.m).
9.
Install gear box cover and air cleaner assembly.
10.
Refill the system with clean fluid.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
OPERATION
DESCRIPTION
TIME
042308A
Replace The Hydraulic
1.3 Hrs.
Booster To Steering Gear
Pressure Line And The
Cooler To Steering Gear
Return Line (Includes Time
To Fill And Bleed Power
Steering System)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
3504
42
Disclaimer