F 350 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
34. Confirm the total preload.
^
Using a Nm (inch-pound) torque wrench, check the torque to rotate the pinion. The reading must be higher than the initial reading (taken
without the differential case installed) by the amount shown, with new bearings installed as recommended.
^
If the total preload is too high, remove an equal amount of differential bearing shims from each differential case hub. If the total preload is too
low, add an equal amount of differential bearing shims to each differential case hub.
35. Carry out the Tooth Contact Pattern Check to verify the final pinion position is correct.
36. Install the axle shafts.
37. NOTE: Install the driveshaft to the index marks made during removal.
Install new bolts and retainers.
38. CAUTION: Clean both flat surfaces (differential housing and differential housing cover) with a suitable solvent to remove all traces of oil film.
CAUTION: Install the differential housing cover within 15 minutes of applying the silicone, or it will be necessary to remove and reapply new
sealant.
NOTE: The differential housing cover requires a silicone rubber sealer material, rather than a gasket.
Apply a continuous bead of sealant of the specified thickness to the differential housing cover.
39. Place two bolts into the differential housing cover at the 8 o'clock and 2 o'clock positions. Install the differential housing cover.
Use the two bolts to position the differential housing cover on the differential housing.
