F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
-
Is any voltage present?
Yes
GO to AE2.
No
GO to AE3.
-------------------------------------------------
AE2 CHECK THE TRAILER ELECTRIC BRAKE CONTROLLER OUTPUT CIRCUIT FOR A SHORT TO VOLTAGE
-
Disconnect: Trailer Electric Brake Controller C2142.
-
Measure the voltage between the trailer tow connector electric brake control supply pin, circuit CAT19 (BU), component side and ground.
-
Is any voltage present?
Yes
REPAIR circuit CAT19 (BU) for a short to voltage. TEST the system for normal operation.
No
INSTALL a new trailer electric brake controller. TEST the system for normal operation.
-------------------------------------------------
AE3 CHECK THE TRAILER ELECTRIC BRAKE CONTROLLER OUTPUT
-
Set the gain on the trailer electric brake controller to the maximum setting.
-
While applying the brake pedal, measure the voltage between the trailer tow connector electric brake control supply pin, circuit CAT19 (BU),
component side and ground.
-
Is the voltage greater than 10 volts?
Yes
The vehicle is operating correctly. SEND the trailer to an authorized camper/trailer repair facility.
No
GO to AE4.
-------------------------------------------------
AE4 CHECK FOR VOLTAGE TO THE TRAILER TOW CONNECTOR (VEHICLE HARNESS)
-
Disconnect: Trailer Tow C4099.
-
NOTE: Make sure the gain is set to the maximum setting.