F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
23. Position the LH battery positive terminal cover aside and disconnect the LH battery positive terminal from the battery.
-
To install, tighten to 12 Nm (106 lb-in).
24. Open the hood latch cable connector housing and disconnect the cable and 2 cable retainers.
25. Remove the LH air deflector pushpin.
26. Detach the power steering hose retainer from the radiator.
27. Disconnect the hood cable retainer from the power steering fluid cooler. Remove the 2 bolts and position the power steering cooler aside.
-
To install, tighten to 11 Nm (97 lb-in).
28. NOTICE: Failure to plug the openings for the transmission cooler hoses may result in siphoning of the transmission fluid. This may result
in damage to the transmission, if the transmission fluid is not checked and topped-off after the repair is complete.
NOTE: Install plugs in the transmission cooler hoses.
Loosen the 2 clamps and disconnect the transmission cooler hoses.
29. Remove the 2 nuts and disconnect the A/C tubes from the condenser. Remove and discard the O-rings and gaskets.
-
To install, use new O-rings and gaskets.
-
To install, tighten to 15 Nm (133 lb-in).
30. Remove the RH air deflector pushpin.
31. Remove the spring clip and disconnect the lower radiator hose.
-
To install, make sure the spring clip is installed correctly.
32. Remove the 2 lower cooling fan shroud bolts.
-
To install, tighten to 7 Nm (62 lb-in).
33. Remove the 6 upper radiator support bolts. With the help of an assistant, remove the cooling module assembly and the RH CAC tube.
-
To install, tighten the upper radiator support top bolts to 40 Nm (30 lb-ft).
-
To install, tighten the upper radiator support front bolts to 63 Nm (46 lb-ft).
34. To install, reverse the removal procedure.
