F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
11. Position the steering shaft into the housing. Install the new steering shaft bolt.
-
Tighten to 48 Nm (35 lb-ft).
12. Position back the master cylinder and bracket. Install the 2 retaining nuts.
-
Tighten to 30 Nm (22 lb-ft).
13. Connect the brake tubes into the retaining clip.
14. Install the ACL assembly and tighten the clamp.
-
Tighten to 5 Nm (44 lb-in).
15. Connect the wiring retaining clip. Connect the MAF sensor and the filter minder electrical connectors.
16. Connect the retaining clip for the power steering cooler tube at the frame.