F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
NOTE: Do not tighten the bolt at this time.
Position the RH engine mount in the frame. Install the new center bolt for the RH engine mount.
6. Lower the engine.
7. Tighten the center bolt for the RH engine mount.
-
Tighten to 350 Nm (258 lb-ft).
8. Position back the transmission cooler tubes on the stud and install the nut.
-
Tighten to 9 Nm (80 lb-in).
9. Position back the ground cable and install the bolt.
-
Tighten to 47 Nm (35 lb-ft).
10. Loosely install the 2 exhaust downpipe bolts.
11. NOTICE: Only use hand tools when installing the transmission mount retaining nuts or damage to the transmission mount may occur.
Remove and discard the 2 transmission mount retaining nuts. Install the 2 new transmission mount retaining nuts.
-
Tighten to 115 Nm (85 lb-ft).
12. NOTICE: Only use hand tools when installing the engine mount retaining nuts or damage to the engine mount may occur.
Install the 3 new LH engine mount retaining nuts.
-
Tighten to 200 Nm (148 lb-ft).
