F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
5. Install the nut on the fuel injector return tube bracket.
-
Tighten to 11 Nm (97 lb-in).
6. Install the fuel filter module and 3 bolts.
-
Tighten to 13 Nm (115 lb-in).
7. NOTICE: Only use banjo bolts with a green hex head. The green-headed bolts do not contain a check valve. When viewed from the inner
end, the correct bolt will appear open. Failure to install the correct banjo bolt may result in damage to the high-pressure fuel injection
pump.
Install new copper sealing washers and banjo bolts at the fuel filter module.
-
Tighten the M14 banjo bolt to 47 Nm (35 lb-ft).
-
Tighten the M12 banjo bolt to 38 Nm (28 lb-ft).
8. NOTICE: Do not bend or flex the heater supply tube or damage to the tube may occur.
NOTE: Install a new O-ring seal.
Install the RH heater supply tube, bolt and nut.
-
Tighten to 13 Nm (115 lb-in).
