F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
25. NOTE: Remove the thermostat housing only if the front cover is being replaced.
Remove the 4 bolts, collar and the thermostat housing.
-
Remove and discard the press-in-place gasket.
26. NOTE: Remove the coolant pump pulley only if the front cover is being replaced.
Remove the 4 bolts and the coolant pump pulley.
27. NOTE: Remove the coolant pump only if the front cover is being replaced.
Remove the 5 bolts and the coolant pump.
-
Discard the O-ring seal.
28. NOTE: Mark the location of the 4 short bolts to aid in installing the oil pump housing.
Remove the 11 bolts and the oil pump housing.
-
Remove and discard the press-in-place gasket.
29. NOTE: Mark the front of each drive rotor for correct reassembly orientation.
Remove the inner and outer oil pump drive rotors.
30. NOTE: Make the location of the front cover fasteners prior to removing them.
Remove the 10 bolts and the engine front cover.
31. NOTICE: Sealant is used where the upper and lower crankcase meet. Failure to cut the sealant may result in pulling the lower crankcase
seal out while removing the front cover gasket.
NOTE: Engine removed for clarity.
Use a thin-blade scraper to cut the sealant where the upper and lower crankcase meet.
-
Remove and discard the front cover gasket.
32. Remove the bolt and the EGR coolant adapter.
-
Remove and discard the O-ring seal.
Installation
All vehicles
1. NOTE: Install a new O-ring seal.
Install the EGR coolant adapter and bolt.