F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
-
Tighten to 7 Nm (62 lb-in).
16. Install the RH high-pressure fuel injection pump heat shield and position the engine-to-body ground wire. Install the 2 nuts.
-
Tighten to 13 Nm (115 lb-in).
17. Install the 3 high-pressure fuel injection pump heat shield bolts.
-
Tighten to 13 Nm (115 lb-in).
18. NOTE: Use a socket to aid on installing the pushnuts.
Install the glow plug module heat shield and 3 new pushnuts.
19. Install the turbocharger inlet pipes. Carry out the Exhaust Gas Recirculation (EGR)-Oxidation Catalytic Converter (OC) and Turbocharger Inlet
Pipes - 6.4L Diesel, Body Off procedure.
20. Install the crankshaft rear seal. For additional information, refer to Crankshaft Rear Seal - Early Build See: Seals and Gaskets/Crankshaft Main
Bearing Seal/Service and Repair/Crankshaft Rear Seal - Early Build or Crankshaft Rear Seal - Late Build See: Seals and Gaskets/Crankshaft Main
Bearing Seal/Service and Repair/Crankshaft Rear Seal - Late Build.
21. Bleed the high-pressure fuel system.
