F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
14. Connect the EP sensor tube fitting onto the EGR-OC pipe.
-
Tighten to 20 Nm (177 lb-in).
15. Install the exhaust downpipe. For additional information, refer to Exhaust Downpipe - 6.4L Diesel See: Exhaust Downpipe.
Exhaust Downpipe
Exhaust Downpipe - 6.4L Diesel
Removal
NOTE: Exhaust fasteners are of a torque prevailing design. Use only new fasteners with the same part number as the original. Torque values must be
used as specified during reassembly to make sure of correct retention of exhaust components.
1. Remove the transmission.
2. If necessary, remove the auxiliary air intake from the cowl.
3. Loosen the exhaust downpipe-to-turbocharger clamp.
-
Discard the exhaust downpipe-to-turbocharger clamp and gasket.
4. Remove the exhaust downpipe-to-Oxidation Catalytic Converter (OC) bolts and remove the exhaust downpipe from the vehicle.
Installation
1. Position the exhaust downpipe into the vehicle and loosely install exhaust downpipe-to-OC bolts.
2. Install a new exhaust downpipe-to-turbocharger gasket.
3. Install the exhaust downpipe to the turbocharger and a new exhaust downpipe-to-turbocharger clamp.
-
Make sure the exhaust downpipe clip is over the lip on the turbocharger.
