F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
9. NOTE: The EGR Valve Puller has a LH thread.
Install the EGR Valve Puller top plate and run the top plate down until it sits on the support rod nuts.
-
It may be necessary to adjust the support rods so that the plate sits squarely on top of the nuts.
10. NOTE: The EGR Valve Puller has a LH thread.
Using the EGR Valve Puller, remove the EGR valve.
-
Discard the O-ring seal.
11. Using the EGR Valve Cleaning Brush and a shop vacuum, clean the EGR valve bore in the intake throttle adapter.
-
Inspect the intake throttle adapter bore for scoring. If the bore is scored, install a new intake throttle adapter.
Installation
All vehicles
1. Using a new O-ring seal, install the EGR valve and the 3 bolts.
-
Tighten to 10 Nm (89 lb-in).
Early build vehicles
2. Connect the coolant inlet and outlet hoses.
All vehicles
3. Connect the EGRT sensor outlet and the EGR valve electrical connectors.
4. NOTE: Clearing the DTCs or Keep Alive Memory (KAM) does not reset the adaptive values in the PCM.
