F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
EGR Temperature Sensor: Service and Repair
Exhaust Gas Temperature (EGT) Sensor
Exhaust Gas Temperature (EGT) Sensor
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTICE: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls or the vehicle may be
damaged.
Turn the ignition switch to the OFF position.
3. Disconnect the appropriate Exhaust Gas Temperature (EGT) sensor electrical connector.
4. NOTE: If necessary, lubricate the EGT sensor with penetrating and lock lubricant to ease removal.
Remove the inoperative EGT sensor.
-
To install, tighten to 30 Nm (22 lb-ft).
5. NOTICE: If the Exhaust Gas Temperature (EGT) sensor bends during installation, do not straighten the EGT sensor. The EGT sensor
will be damaged if it is straightened. Discard the EGT sensor and install a new sensor.
To install, reverse the removal procedure.
