F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
8. Turn the ignition key ON without starting the engine.
9. Wait 30 seconds for the fuel conditioning module to run.
10. Turn the ignition key OFF.
11. Repeat Steps 8, 9 and 10 three times before starting the engine.
12. Turn the ignition key ON and make sure fuel system pressure is within the specified range. For additional information, refer to Specifications.
13. Turn the ignition key OFF.
14. NOTE: Open the drain valve slowly to relieve the fuel system pressure. This may drain fuel from the system. Place the fuel in a suitable container.
Once the fuel system pressure test is complete, open the drain valve on the Fuel Pressure Test Kit and relieve the fuel system pressure.
15. If a no start condition still exists, perform the high-pressure fuel system bleed. For additional information, refer to Fuel System Bleeding - High
Pressure, Diesel Engine See: Fuel System Bleeding - High Pressure.
16. Install the Schrader valve cap.
