F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
Removal
Both sides
NOTE: It is recommended that this component be serviced with the vehicle body removed. If the body cannot be removed, refer to Fuel Rail Supply
Tube - Body On See: Fuel Rail Supply Tube - Body On.
1. WARNING: Do not work on the fuel system until the pressure has been released and the engine has cooled. Fuel in the high-pressure fuel
system is hot and under very high pressure. High-pressure fuel may cause cuts and contact with hot fuel may cause burns. Failure to
follow these instructions may result in serious personal injury.
Shut the engine off and wait until the engine is cool or 5 minutes, whichever is longer, to allow the high-pressure fuel system pressure to bleed off
and the fuel to cool.
2. Remove the vehicle body.
3. Loosen the exhaust downpipe-to-turbocharger clamp.
4. Remove the 2 exhaust downpipe-to-Oxidation Catalytic Converter (OC) bolts and remove the exhaust downpipe from the vehicle.
-
Discard the clamp and gasket.
5. Disconnect the Exhaust Gas Recirculation Temperature (EGRT) sensor electrical connector.
6. Disconnect the Exhaust Pressure (EP) sensor tube fitting.